English — Forum #647 (Page 15/34)
- Construction site tower safety management system Construction site tower visualization system - HCBBS Forum
- Causes of gas resistance in catalytic desorption towers and treatment methods - HCBBS Forum
- Reason why the pressure at the top of the atmospheric pressure tower is close to the pressure in the reflux tank - HCBBS Forum
- Adjustment of the extraction efficiency in the extraction tower - HCBBS Forum
- How does Aspen calculate batch distillation columns? - HCBBS Forum
- Hoisting and installation of methanol synthesis tower at Shaanxi Jingyi Chemical Industry - HCBBS Forum
- 55 people held accountable for the Haizhu tower crane collapse accident - HCBBS Forum
- I’d like to learn about the purification at the top of a fractionation tower*; are there any experts who can explain it? From the isobutane removal tower: the pressure is 0.59 kilograms; the maximum reflux temperature is 123°C. Over a period of four days, the purity of isobutane at the tower top was 66%, while that of n-butane was around 28%. The feed rate was 122 - HCBBS Forum
- PH of the quench tower in the sulfur recovery unit - HCBBS Forum
- The undriven end of the distillation column bottom pump experiences significant vertical vibration - HCBBS Forum
- When using ASPEN for tower simulation, how can the actual number of theoretical plates be determined from the theoretical value? - HCBBS Forum
- Distillation column volume issue - HCBBS Forum
- The bubble factor is required in tower design - HCBBS Forum
- The azeotropic distillation column in the MTBE plant experiences large pressure fluctuations during operation - HCBBS Forum
- Phenol propylation unit: Oxygen content monitoring at the outlet of the isopropylbenzene oxidation tower - HCBBS Forum
- So this is what the actual tower equipment and its internals look like! - HCBBS Forum
- Who has the methods and pictures for on-site assembly of tower equipment? - HCBBS Forum
- The significance of opening and closing the valve on the pipeline from the bottom of the tower to the dirty nitrogen pipeline in the internal compression process, or the purpose of installing such a pipeline - HCBBS Forum
- May I ask: is the nitrogen that condenses and liquefies as it rises to the main cooler from the air coming out of the lower column, all of the nitrogen contained in the total amount of material in that air from the lower column? - HCBBS Forum
- Investigation Report on the Serious Accident Caused by the Collapse of a 35KV Tower in Yunnan, Resulting in 4 Deaths | 4 Persons Including the Project Leader and Supervisors Were Held criminally liable - HCBBS Forum
- Solvent regeneration tower with bottom sump - HCBBS Forum
- Discussion on the setting of distillation column pressure - HCBBS Forum
- Factors affecting the bottom liquid level in a distillation column - HCBBS Forum
- Preventive measures for tower crane safety accidents - HCBBS Forum
- Distillation tower cleaning interlock scheme - HCBBS Forum
- What material should be used for the MDEA solvent regeneration tower? Can carbon steel be used? - HCBBS Forum
- Alkylation deisobutanizer tower - HCBBS Forum
- Design of tray plates and their support rings - HCBBS Forum
- Design and selection of benzene clay towers - HCBBS Forum
- Heat bypass pressure of the stabilizer tower - HCBBS Forum
- Dangers of high liquid temperature in the stripping tower - HCBBS Forum
- Seeking advice on simulating distillation columns using Aspen Plus - HCBBS Forum
- Tower equipment - HCBBS Forum
- Operation of the amine solution regeneration tower - HCBBS Forum
- A brief discussion on the development and applicability of water-driven fan cooling towers - HCBBS Forum
- Fixing method of support beams inside the desulfurization spray tower to the tower wall - HCBBS Forum
- More light components are entering the distillation column - HCBBS Forum
- Calculate how much ammonia and hydrogen sulfide are produced by the tower - HCBBS Forum
- May I ask which section is referred to as the tangent height of the tower equipment? Thank you! - HCBBS Forum
- Distillation atmospheric tower air cooler water cooler settings - HCBBS Forum
- High and low pressure falling film evaporators - HCBBS Forum
- Learn more from pictures: tower equipment such as spray towers, cooling towers, and acid mist absorption towers - HCBBS Forum
- Safety measures for hot work during the demolition of benzene removal towers and benzene washing towers - HCBBS Forum
- How to control a distillation tower and operate it smoothly? Please share your experience - HCBBS Forum
- Single-tower pressurized side-line ammonia extraction process. What causes a low ammonia extraction rate? - HCBBS Forum
- How to establish the reflux at the top of the solvent regeneration tower - HCBBS Forum
- Vibration problems in the solvent regeneration tower of aromatic extraction units - HCBBS Forum
- Reasons for high top temperature in the hydrogen sulfide removal tower for acidic water treatment and its impacts - HCBBS Forum
- The working principle of a cooling tower - HCBBS Forum
- Help: Regeneration tower flooding - HCBBS Forum
- Issues regarding the installation of the top condenser in the atmospheric pressure column for methanol distillation - HCBBS Forum
- Calculation of pipe diameter for saturated hot water towers - HCBBS Forum
- Corrosion and leakage in tray-type towers - HCBBS Forum
- I would like to ask how to determine the air leakage coefficients for desulfurization towers, denitrification reactors, and dust collectors? - HCBBS Forum
- Tower Principle - HCBBS Forum
- Should a natural gas dehydration dryer be equipped with four towers or three towers? - HCBBS Forum
- In A+, what is used to simulate the cooling effect of water spray in the quench tower? ! - HCBBS Forum
- Material selection for hydrogen chloride absorption towers - HCBBS Forum
- Distillation tower structural drawing - HCBBS Forum
- How is the tower diameter defined in the calculator of Aspen? - HCBBS Forum
- What are the consequences of an alarm for high tower pressure in the hydrogen sulfide concentration tower? What impact does it have on the backend system? - HCBBS Forum
- Methods for dealing with frozen blockages in the bottom drain pipe of a fractionation tower - HCBBS Forum
- What should be noted when entering an enamel tower through a manhole to install packing? ? - HCBBS Forum
- I would like to ask everyone: in the shift responsible for coal-based ammonia synthesis, in the process of converting high-pressure gas to low-pressure gas and which involves hot water towers, what effects will there be if lubricating oil is directly added to the hot water pump while it is in operation? - HCBBS Forum
- There is a lot of sludge in the packing layer of the drying tower - HCBBS Forum
- Distillation column cleaning issue - HCBBS Forum
- How to reduce the hydrocarbon content in the rich liquid from the unit’s dry gas desulfurization tower - HCBBS Forum
- Will the purity of the light components at the top of the distillation column decrease after the column is flooded? - HCBBS Forum
- A tower crane at a construction site in Handan, Hebei, collapsed; authorities ordered a complete suspension of work for rectification - HCBBS Forum
- Issues with the evaporation section of the delayed coking fractionation tower – please advise, experts. - HCBBS Forum
- Original by HaiChuan: Simulating an absorption tower in Aspen Plus doesn’t seem that difficult either - HCBBS Forum
- What is the method for indicating openings in the steel platform floor of 33m tower equipment? - HCBBS Forum
- Post #1958310
- Calculation of coke tower foundation and tower structure - HCBBS Forum
- Internal structure of the distillation tower top reflux drum - HCBBS Forum
- Seeking expert advice: How to determine the inlet location of a distillation tower - HCBBS Forum
- Abnormality in the feed heater of the tri-effect tower for furfural waste oil - HCBBS Forum
- Problems in the design specifications of ASPEN absorption towers - HCBBS Forum
- of the methanol synthesis tower - HCBBS Forum
- , - HCBBS Forum
- Frequent tower flooding in the amine solution regeneration tower - HCBBS Forum
- What type of level gauge is suitable for use in a vacuum distillation tower? - HCBBS Forum
- If the reflux ratio in a distillation column is increased, with all other conditions remaining unchanged, how will the content of light components in the bottom of the column change? - HCBBS Forum
- Distillation tower for synthesizing mtbe - HCBBS Forum
- Why is the pressure at the top of our pressure relief tower lower than that of the Roots vacuum pump system? - HCBBS Forum
- Is the acidic water at the top of the coal tar pretreatment tower salty? - HCBBS Forum
- Cold material enters the tower - HCBBS Forum
- What does \"the tower body\" refer to in the requirements regarding the straightness of the tower body and its vertical installation? ? ? - HCBBS Forum
- What happened during the emergency repair of the absorption tower trays back then - HCBBS Forum
- What is the effect of the residence time of slag reduction at the bottom of the tower on the amount of non-condensable gas? - HCBBS Forum
- How to deal with foam in a biological absorption tower - HCBBS Forum
- Are guard plates required at all the connections where ladders or other supports for tank or other tower wall equipment are attached to the equipment? - HCBBS Forum
- Reasons for tube failure in methanol synthesis towers - HCBBS Forum
- In the methanol wash medium-pressure flash tower, the methanol-rich stream going to the CO2 stripping tower enters either the upper section or the middle section; are there any requirements for the lower section? - HCBBS Forum
- distillation tower - HCBBS Forum
- 12 animations demonstrating the working principles of various tower equipment - HCBBS Forum
- Carbon dioxide stripping tower - HCBBS Forum
- Problems that occur in the rigorous calculation of distillation columns in ASPEN PULS - HCBBS Forum
- Is coking liquefied gas in gaseous or liquid form in the desulfurization tower? - HCBBS Forum
- Liquid spray device and distributor of the packed tower - HCBBS Forum